Tubelight MULTI LV PRO
"There is a Tubelight Multi LV Spotlight to accept any of the lamps shown below.."
MR8 12V G4 20W or 35W Halogen Diameter - 25mm	MR11 12V G4 10W, 20W or 35W Halogen Diameter - 35mm	MR16 12V G5.3 20W, 35W or 50W Halogen Diameter - 50mm	MR11 12V G4 1.1W LED Cluster Diameter - 35mm	MR16 12V G5.3 1.5W LED Cluster Diameter - 50mm	MR16 12V G5.3 Triple High Power 4W & 5W White & Warm White LED Diameter - 50mm
MR11 GU4 Spotlights			MR16 GU5.3 Spotlights
S112 Cap - GU4 Lamp - 12V MR8 or MR11 Max Wattage - 35W			S122 Cap - GU5.3 Lamp - 12V MR16 Max Wattage - 50W
S111 (Cowled) Cap - GU4 Lamp - 12V MR11 Max Wattage - 20W			S121 (Cowled) Cap - GU5.3 Lamp - 12V MR16 Max Wattage - 20W
Tube
TUBE DIAMETER - 9.6mm (3/8")
Bases / Fixings
RF10 Rear Fix Base Plate Diameter - 22mm Fixing - M10 thread, nut & washer		FF10 Front Fix Base Plate Diameter - 30mm Fixing - 2 concealed screws		CP10 Ceiling Plate Diameter - 54mm Fixing - 2 concealed screws

Information for ordering Tubelight MULTI Display Luminaires:

CS2.300.0.S112.03 + RF10.03

When ordering Tubelight Multi please use the following codes: 1. Configuration e.g. CS2 - 2 Way (180º Spacing) CS4 - 4 Way (90º Spacing) 2. Overall height e.g. 300 (300mm) (Measured from the face of the display to top of spotlight, not including lamp) 3. Overall Width e.g. 0 ("0" Denotes no tube extension but if wider luminaires are required please state overall width measured at widest point between 2 opposite spotlights) 4. Spotlights e.g. S112 (Any of the 12V spotlights pictured above.) 4. Finish .03 - Chrome .05 - Brushed Chrome/Stainless Steel Effect ( .01 - White, .02 Black & .04 Brass are still available but have been reclassified as non standard finishes and from the end of October 2005 will incur a setup charge to cover extra costs involved.) 5. Base Fixing e.g. RF10 - Rear Fix Base Plate (Any of the Bases pictured above.)